Due to a promotion, we are seeking an experienced Finisher II. This position will at first be pay-rolled through a temp agency.
Candidates should have about 3 years of stainless steel finishing experience, be able to read dimensional drawing and tolerances and ensure that parts conform to tight tolerances. You will…
– Manipulate more complex parts to match print and dimensional specifications
– Ensure that parts are not over or under finished
– Read dimensional drawings and tolerances
– Finish parts to acceptable standards insuring customer satisfaction
– Ensures that material surface area is not scratched or damaged and ends of tubes are square and free of burrs
– Ensures parts conform to tight tolerances
– May work with manufacturing and quality engineers to resolve complex finishes
– Perform peening on parts
– Ensure tube ends are capped
– Perform laser etching on parts
– Minimal defects, 99.8% acceptance
– May perform DI rinse
– Perform peer inspections
– Ensure all equipment is calibrated to proper specifications
– Use hand and small power tools
– Maintain the work area and equipment in a clean and orderly condition and follows prescribed safety regulations
Please submit a resume.